[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Fwd: upgrading the University of Richmond cluster]

hi sasko,

   it looks like the backup worked last night and we didn't throw
any circuit breakers. if there are any problems let me know. i
have attached an email message that i received this morning from
steven james on the steps for upgrading the software. please
look it over and let me know what you think. there are a few
of things to consider.

1. does steven james's plan sound resonable?

2. can you get all this stuff done before the end of the day on
monday?

3. if not, what can be finished? we'll see if an old, senile
professor like myself can do the rest.

let me know what you think.

jerry

-- 
Dr. Gerard P. Gilfoyle
Physics Department                e-mail: ggilfoyl@richmond.edu
University of Richmond, VA 23173  phone:  804-289-8255
USA                               fax:    804-289-8482
--- Begin Message --- 
Greetings,


For minimum disruption, I propose that the upgrade proceed in several
steps.

1. Secondary master shut down and disconnected from cluster (ethernet
cable).

2. re-configure BIOS to boot from CDROM, then hard drive

3. Install RedHat 7.2 (later versions not advised at this time)

4. Make sec. master available on public network for access by LinuxLabs.

5. I will install Nimbus enhancements on secondary master and do
preliminary configuration.

6. back up all user data on master and compute nodes to fileserver.

7. Primary master shut down. re-designated as secondary master

8. Secondary master connected to cluster and re-designated as master.

9. Final configuration. Some local intervention will be needed to boot
compute nodes. 

10. new sec master set for PXE boot in BIOS and booted.

11. I will re-configure sec master. Primary's image will be copied to
secondary.

For step 3 (RedHat install), a special partitioning will be required.

use fdisk to partition hda! Partition as follows (order IS important!)
hda3 500M
hda2 500M
hda1 (as desired for scratch, not less than 1G)
hda4 extended, rest of drive

hda5 3G
hda6 rest of drive

Note that 5 and 6 are extended partitions inside hda4.

The partitions should be created in the order listed here in order to make
sure booting will work! Druid will tend to get it wrong.

Then, edit the partitions to specify filesystem and mountpoint as follows:

hda1 ext3fs /scratch
hda2 swap
hda3 ext3fs /
hda5 ext3fs /var
hda6 ext3fs /usr

Package installation:
Select Custom install.
Keep all default selected packages except for dialup

In addition, select:

NFS server
development tools
kernel development
firewall/router

You may also select any other task/package sets desired.

In firewall setup, allow at least ssh (others as you see fit)
eth2 MUST be set as a trusted interface.

Continue with installation as usual. Send me and Markus IP address and
(temporary) root password when ready (step 4).

G'day,
sjames



On Wed, 30 Oct 2002, gilfoyle wrote:

> Hi Steven,
> 
>    What would be a good to arrange for an upgrade of the University
> of Richmond cluster to the Nimbus system?
> 
> cheers,
> 
> jerry gilfoyle
> 
> 

-- 
-------------------------steven james, director of research, linux labs
... ........ ..... ....                     230 peachtree st nw ste 701
the original linux labs                             atlanta.ga.us 30303
      -since 1995                              http://www.linuxlabs.com
                                   office 404.577.7747 fax 404.577.7743
-----------------------------------------------------------------------

--- End Message ---